Oracle Solaris Administration: IP Services Oracle Solaris 10 1/13 Information An IPMP configuration typically consists of two or more physical interfaces on the . For IPMP configuration tasks, refer to Chapter 31, Administering IPMP (Tasks). Oracle Solaris IPMP involves the following software: You can configure one of the interfaces down to 10 megabits and still place the two interfaces into the. You must have configured all interfaces as members of the IPMP group. role to a user, see Chapter 2, Working With the Solaris Management Console (Tasks).
|Published (Last):||11 May 2014|
|PDF File Size:||6.62 Mb|
|ePub File Size:||8.72 Mb|
|Price:||Free* [*Free Regsitration Required]|
U are master of UNIX.
How to configure Solaris 10 Link Based IPMP – The Geek Diary
Consider the example of four VLANs, bgesolzrisbgeand bge Now i am going to enable it back. Preventing Applications From Using Test Addresses After you have configured a test address, you need to ensure that this address is not used by applications.
When an ocnfiguration is considered repaired, any addresses that failed over to another interface then fail back to the repaired interface. You can add new interfaces to an existing group on a live system. IPMP does not permit you to add a data address to an interface that is configured through the ifconfig command as standby. Detaching NICs All requests to detach system components that contain NICs are first checked to ensure that connectivity slaris be preserved.
Routers that are connected to the IP link are automatically selected as targets for probing.
In a dual-stack environment, placing the IPv4 instance of an interface under a particular group automatically places the IPv6 instance under the same group. The port on the switch does not transmit or receive packets.
If an interface with the same name as another interface that was missing at system boot is reattached using DR, RCM automatically plumbs the interface. Note that the in.
Chapter 30 Introducing IPMP (Overview)
RCM has no information regarding how to configure the interface. Paid Training Courses we Offer. One consequence of this situation is that addresses that were previously failed over to another interface are not failed back.
For example, you would create the following test address for the primary network interface hme Specific information about DR in the Sun Cluster environment. Arena-Node1 ifconfig eg1 Then, the standby interface is treated the same as other active interfaces until the failed interface is repaired. Finally, RCM fails back any data addresses, just as if the interface had been repaired. A multicast packet that is sent to the all hosts multicast address, You can run Oracle Solaris 11 in manual fixed and automatic reactive network configuration mode, so either the DefaultFixed network configuration profile NCP or the Automatic NCP is activated on the system.
Thank you so much brother. This action is not shown in the examples.
You use Ocnfiguration options of the ifconfig command to create the configuration. Probe traffic helps to determine the status of the interface and its NIC, including whether an interface has failed. Reboot the system after any changes to verify you have unique mac addresses now. In this instance, in. The probing rate depends on the failure detection time FDT. Its really awesome article. If any of these steps fail, or if the DR of other hardware on the same system component fails, then the previous configuration is restored to its original state.
You cannot place two interfaces of different media types into an IPMP group. All interfaces in an IPMP group must be of the same media type. The interfaces are configured as members of the same IPMP group.
Add Data IP Address es to the group. Note solairs You can always view the current status of an interface by typing the ifconfig interface command. Planning an IPv6 Network Tasks. After the daemon receives 10 consecutive replies for a default repair detection time of 20 seconds, the daemon determines that the interface is repaired.
Then, the NIC is unplumbed from the system. In this instance, the test IPv4 address is configured only on the next reboot. Additionally, any existing connections to the system using those IP addresses are disrupted.